Irrigation system installation, repair, and smart controller upgrades in Jacksonville and NE Florida. Free quotes from local pros on YardLink.
Find Irrigation Pros Near YouAn efficient irrigation system is one of the most valuable investments a NE Florida homeowner can make. Jacksonville averages 52 inches of rainfall per year — more than Seattle — but that rain falls heavily in summer afternoon thunderstorms and then stops almost completely from October through May. Without irrigation, St. Augustine lawns and landscape beds can suffer severe drought stress during the dry season, turning brown and thinning out in ways that invite pest and disease pressure.
Automatic irrigation systems in NE Florida typically cover lawn zones with rotary or fixed spray heads and separate drip zones for planting beds, trees, and shrubs. A properly designed system separates the lawn (which needs about 3/4 inch of water per application) from ornamental beds (which need far less) and from trees (which benefit from deep, infrequent watering). Mixing these on the same zone is one of the most common irrigation design mistakes local technicians encounter.
St. Johns River Water Management District (SJRWMD) governs irrigation schedules for NE Florida. Depending on your address, year-round lawn irrigation is restricted to 2 days per week or 1 day per week during certain periods. Violating these rules carries fines. Smart irrigation controllers with weather-sensing technology — a requirement for new systems and strongly recommended for retrofits — automatically skip scheduled runs when rainfall is detected or when evapotranspiration data indicates no watering is needed, keeping your schedule compliant and your water bill low.
Irrigation systems in NE Florida face specific challenges. The sandy soils common across the region drain quickly, meaning shorter, more frequent run cycles often perform better than long single runs. On the other hand, poorly drained areas near the St. Johns River and in low-lying coastal neighborhoods can become oversaturated, leading to fungal lawn diseases like brown patch and gray leaf spot when irrigation is added on top of natural rainfall. A competent irrigation technician will evaluate your drainage before programming your controller.
New irrigation system installation in the Jacksonville area typically runs $2,500–$5,500 for a standard residential lot of 6,000–10,000 square feet, covering 4–6 zones. System repair, head replacement, and controller upgrades range from $75 for a simple head replacement to $500+ for controller installations and significant pipe repairs.
No verified pros yet
Be the first irrigation business listed in NE Florida on YardLink.
Create Your Business ProfileUnder St. Johns River Water Management District rules, most NE Florida properties are limited to twice-per-week irrigation year-round (odd addresses on Wednesday/Saturday, even on Thursday/Sunday). During declared water shortage periods, restrictions tighten further. Your smart controller can be programmed to comply automatically.
Your system either lacks a rain sensor or the sensor has failed. Florida law requires all automatic irrigation systems to have a functioning rain sensor or weather-based ET controller. A rain sensor costs $25–$75 plus installation and will save you significantly on water bills while keeping you in compliance.
Look for dry patches (head not covering the area), wet spots or puddling (too much water or improper spray pattern), water hitting driveways or sidewalks (head misaligned), and brown rings around heads (head sinking or clogged). A twice-annual irrigation inspection by a licensed contractor catches these issues before they cause lawn damage.
Yes, for most NE Florida homeowners this is one of the best irrigation investments. Smart controllers use local weather data and evapotranspiration calculations to automatically adjust watering schedules, saving 20–50% on irrigation water compared to a timer-based controller. Many local utilities offer rebates for smart controller installations.
Low pressure in specific zones is usually caused by a broken pipe underground, a partially closed zone valve, clogged drip emitters, or too many heads on a single zone. A licensed irrigation contractor can perform a zone-by-zone pressure test and flow analysis to identify the problem precisely.